Flange for intermediate shaft Defender TD4 reinforced

Original Land Rover Defender TD4 intermediate shaft The biggest weak point in all Land Rover Defender TD4 models from 2007 to end of production is the intermediate shaft of the manual gearbox Getrag MT82 and the LT230 transferbox. The problem lies on the one hand in the fact that this shaft was installed ex works without grease, on the other hand condensation forms in the gearbox housing. The exhaust system is right next to it, so there are constant temperature differences and condensation even forms inside the gearing. Time does the rest. The gear teeth on the gear shaft and on the flange start to corrode. The constant load cycling reduces the gearing until it is completely worn down and spins out. Newer Defender TD4 with 2.2 liter engines from the 2012 model year, have this problem sometimes much earlier. We had vehicles that stopped after only 15,000 km. After replacing the part number from LR006090 to LR030054, the quality of the transmission flange probably deteriorated significantly. Information Installed quantity 1 piece Suitable for Defender Td 4 from year of manufacture 2007 to 2016 Quality Land Rover Genuine

Spezialschraube Zwischenwelle Land Rover Defender TD4 Land Rover Defender TD4 Spezialschraube für den Flansch der Zwischenwelle des MT82 Schaltgetriebe. Informationen Verbaute Menge / Fahrzeug 1 Stück Passend für Defender TD4 alle Modelle Qualität Land Rover Genuine original Ersatzteile

Improved intermediate shaft Defender - ENGAGE4X4 set in reinforced version. The Land Rover Defender TD4 has been equipped with a new engine and a new six speed gearbox from Getrag MT82 since 2007. However, since this gearbox was developed for the Ford Transit, it does not fit the Land Rover LT230 transfer case. To connect the Getrag gearbox with the Land Rover Defender transferbox, the manufacturer has developed a so-called Defender TD4 intermediate shaft in a housing instead of a cardan shaft connection to connect both gearboxes. In the first TD4 models this problem was not so present. Approximately in 2010 the part numbers of the flange were replaced. We assume there was a manufacturer change here. The built-in weak point of the Defender from factory ENGAGE4X4 improved intermediate shaft The flange of the Defender TD4 intermediate shaft is in a cast aluminum housing and was installed dry from the factory. The proximity to the exhaust pipe and thus constant temperature changes allows condensation to form in the splines and the intermediate housing. The gearing begins to corrode over time. The corrosion dust and load change impacts do the rest. The gearing steadily reduces. We have had vehicles with just about 18,000 km in our shop that have stopped at absolute wear. Failure of the Defender TD4 intermediate shaft means total loss of mobility. This is absolutely unfavorable for expedition vehicles traveling to remote regions in Africa, Asia, or Russia. The possible solutions for the problem of the Defender TD4 intermediate shaft There have been a few attempts to solve the problem, but all have been less than fruitful. Land Rover issued a circular instructing the dealers to use a special grease on the TD4 intermediate shaft, but this was not the solution in our opinion, some vehicles still had this problem several times. There was still the approach to lubricate the shaft with a kind of oil connection, here was not considered however. One builds in another weak point, an additional oil seal with the possibility for an additional oil loss. There are also cases that the shaft is broken under extreme loads, as it is also a material problem. The ENGAGE4X4 solution for the Defender TD4 transmission shaft For years we have spared no expense and effort to have a reinforced transmission shaft and flange manufactured in Germany. Together with info from Getrag we were able to determine the exact data of the gearing and paid high tooling costs and developed a flange from S155 (300 M) and a TD4 gear shaft also from S155 (300M). The material S155 corresponds to the common American designation 300M. The material has a load capacity of 1800 to 2000Nm / mm². It is the strongest material that can be used in drive technology. Special properties are high flexibility and very good corrosion resistance. Not enough, we have also thought about the sealing of our shaft and have a special heat-reducing seal manufactured, which ensures a 100% tightness. The shaft is also mounted for safety with an assembly paste. The special sleeve is then shrunk on. There are no more problems. We give 3 years warranty. Information Gear shaft with OE part number TUD500020 in reinforced version from S155 Gearbox shaft flange with OE LR030054 in reinforced version from S155 Special reduced sealing sleeve with sealing glue Made in Germany 3 years warranty

Flange for intermediate shaft original Land Rover Defender TD4 The biggest weak point in all Land Rover Defender TD4 models from year of manufacture 2007 until end of production is the connection of the intermediate shaft and the flange of the manual gearbox Getrag MT82 and the LT230 transferbox. The problem is on the one hand that this shaft was installed from the factory without grease, on the other hand condensation forms in the gearbox housing. The exhaust system is right next to it. Therefore, there are constant temperature differences and condensation even forms inside the gearing. Time does the rest. The gearing on the gear shaft and on the flange start to corrode. The constant load cycling reduces the gearing until it is completely worn down and spins out. Newer Defender TD4 with 2.2 liter engines from the 2012 model year, have this problem sometimes much earlier. We had vehicles that stopped after only 15,000 km. After replacing the part number from LR006090 to LR030054, the quality of the transmission flange probably deteriorated significantly. Information Installed quantity 1 piece Suitable for Defender Td 4 from year of manufacture 2007 to 2016 Quality Land Rover Genuine

Gasket for intermediate shaft Land Rover Defender TD4. Sealing ring for intermediate shaft of Land Rover Defender manual transmission MT82 and the transmission flange. Information Installed quantity / vehicle 1 piece Quality Land Rover Genuine