ENGAGE4X4 spring guide cones Defender 110 / 130 rear axle

The height-adjustable ENGAGE4X4 shock domes for the Land Rover Defender front axle allow, for example, the installation of higher springs in conjunction with shock absorbers in original length or vice versa. There is also the possibility to improve the axle articulation on the front axle, especially with progressive springs with coil-off on the front axle. ENGAGE4X4 quality suspension for Land Rover Defender Fully manufactured in the EU, these ENGAGE4X4 height adjustable shock domes for the Defender can be raised to various heights from 50mm to 100mm lowered. This allows to find the right compromise between articulation and spring preload for any suspension / shock combination. The damper domes are made of 6 mm thick high-strength steel (S355), welded using TIG technology, galvanized and coated with polyester powder. The damper domes are particularly resistant to chemicals and weathering. They are also scratch and abrasion resistant. Indispensable when the driving range has to be changed quickly or when the shock absorbers have to be replaced. The actual amount of suspension travel required is not known or cannot be determined. It is possible to install shock absorbers longer than the original ones, even if the standard springs or shock absorbers are longer than the actual upward travel of the springs, without losing compression or spring preload or, on the contrary, to install shock absorbers shorter than the spring height without losing travel. The right compromise between the two extremes! Made in EU Material S355 high tensile steel Surface EPS powder coating Height adjustable

ENGAGE4X4 Polyurethane spring cones for Defender front axle. This pair of spring guide cones for the Land Rover Defender front axle is made entirely in the EU. To achieve a longer suspension travel, the cones are essential for the Defender to bring the front springs back to the original position. Especially if longer shock absorbers are used. This is an easy and inexpensive way to increase the mobility of the front axle suspension. The off-road capability improves many times over. The ENGAGE4X4 spring cones are made of HDPE polyethylene. It improves the glide and avoids annoying noise during the movement. The Defender Spring Cones are CNC lathe perfectly shaped to provide maximum resistance with minimum mass.