Bolt set cardan shaft rear axle

Cardan shaft bolt for cardan shaft front axle & rear axle differential. Connects propshaft to differential. Information Defender (1984 - 2006) Discovery 1 & 2 (all) Range Rover classic (all) Installed quantity 8 pieces

Double-joint propshaft Land Rover Defender When the chassis is raised more than 25 mm, rotational vibrations occur in the driveline of the Defender TD4. These mostly occur in the, at a speed of slightly more than 80 km/h and can damage the transfer case in the long run. The ENGAGE4X4 double-joint propshaft prevents the vibrations in the driveline of the raised Defender through a stress-free working angle. In this way, height increases of around 100 mm are possible. Thus, the ENGAGE4X4 double-joint propshaft is absolutely necessary for Land Rover Defenders with a suspension lift, in order to carry out a durable suspension modification on the Defender. Another special feature is the new lubricatable sliding piece developed by ENGAGE4X4, here the grease nipple is protected, so that the shaft can be maintained even after extreme off-road use. Continuous improvement and long-term testing in our vehicles. In 2018, a journey was started from Germany to Mongolia and back around 20,000 km, including 3,500 km under the most adverse conditions in the steppe of Mongolia and many off-road passages in Russia and Kazakhstan. The ENGAGE4X4 double-jointed cardan shaft had been installed for more than 6 years at this point and had run 45,000 km with a suspension increase of 80 mm. Also on this tour no defect was found at the shaft. Our ENGAGE4X4 double-joint cardan shaft has gone through a steady improvement trip over 9 years. Countless improvements, tests with the manufacturer and durability tests as well as long-term tests over years have made this propshaft unique. Available for all Land Rover modelsFor the Land Rover Defender suitable for the front axle and the Defender 90 TDI & TD5 suitable for the rear axle. The ENGAGE4X4 propshafts are designed for very heavy duty off road use. The sliding piece of this Defender propshaft is protected with a Simmering against the penetration of dirty water. The reinforced universal joints can be lubricated. The shaft operates stress-free at large interlocks at angles up to 35°. Information Land Rover Defender TD4 (all models) on the front axle Land Rover Defender 90 TD5 & TDI on rear axle Cross sets: Reinforced 30mm (greasable) Length compensation: 110mm Sliding piece: Toothing plastic coated and sealed with Simmering (greasable) Flange: Fits flange (original Defender flange) Manufacturer Standard: ISO:9001 & TS:16949 ApplicationsOff Road, Trophy, Rally Raid, protected vehicles, higher mounted vehicles, expedition vehicles for long distance travel

Mounting kit for Land Rover propshaft rear axle. No need to search for spare part numbers, just order a preassembled mounting kit. You want to replace the propshaft or universal joints. Just order a ready made repair kit and save valuable time. Information: 4 x 509045P - Bolt Differential Side4 x FRC3602 - UNF fBolt Handbrake Drum8 x NZ606041L - Fuse Nyloc Nut Fits for: Defender (all models)